2D gel running problem
Hi I've been having a certain problem when running my 11cm 2D gels in a Criterion gel tank by Bio-Rad. I run them under constant voltage conditions of 200V but I seem to get really low mA values. As a result my gels will either not run at all giving me a total smear when stained or stop running midway through. Additionally it takes 2-3 hours for them yo run as opposed to 50 min previously. Lately I have been having the same problem with my 1D gels as well. From that I thought that the problem was with my electrical source ( PowerPac 300) but I switched it with another one that we had in the lab but still have the same problem. Any ideas on what maybe at fault or what to do?
|All times are GMT. The time now is 05:23 AM.|
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright 2005 - 2012 Molecular Station | All Rights Reserved