Science Forums Biology Forum Molecular Biology Forum Physics Chemistry Forum

Science Forums Biology Forum Molecular Biology Forum Physics Chemistry Forum (http://www.molecularstation.com/forum/)
-   DNA Techniques (http://www.molecularstation.com/forum/dna-techniques/)
-   -   Grass DNA extraction issue (http://www.molecularstation.com/forum/dna-techniques/87847-grass-dna-extraction-issue.html)

meltvariant 05-02-2013 11:20 PM

Grass DNA extraction issue
 
Hello, I am having a bit of trouble with a genomic DNA extraction and could use some advice in pinpointing the problem(s).

I have a larger number of grass (C4 tallgrass) samples that I intend to run through reduced-representation sequencing, on the order of 1000, with many more in the future. To handle this large number, I decided to go with Qiagen's 96 DNeasy plant kit. I found out too late however, that the best centrifuge available can induce up to 2250 *g, whereas the protocol recommends much greater force, 5800 *g. I decided to give it a trial run anyway, and doubled the spin times to try to compensate. The filter appeared to be dry after each of the spins. Unfortunately, however, the yield was far lower than hoped (~1.2ng/ml).

This could obviously be due to the centrifuge issue, or it could be that the bead beating was ineffective during lysis on Qiagen's TissueLyserII. While there was some clear evidence of cellular debris following the neutralization step, there wasn't as much as I am used to from doing bacterial mini-preps, and the leaves of grass still looked fairly intact.

Any thoughts on whether one, the other, both, or neither of these possible issues are the culprit?

One additional note: these leaves were dried and stored using silica gel beads last summer, so they are bit aged, but not unheard of.

Thanks in advance!


All times are GMT. The time now is 01:35 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright 2005 - 2012 Molecular Station | All Rights Reserved

Page generated in 0.08948 seconds with 11 queries